Stall Layouts for Champ Floor Anchor Pots

Stall Layouts for

Floor Anchor Pots

STALL NO. 1 - 24 pots
The ideal stall for the Uni-Bench. Max 6 ft spacing for perimeter pots plus 10 pot interior. Ability to make any pull (including twist from front rails, rear rails and passenger section).

STALL NO. 2 - 18 pots
Alternate stall for the Uni-Bench. 8 ft spacing for perimeter pots adequate for most pulling situations. 6 pot interior allows Uni-Bench to be securely tied down.

STALL NO. 3 - 18 pots
4 pot interior for old technology ladder frames. Best spacing for perimeter pots.

STALL NO. 4 - 16 pots

STALL NO. 5 - 14 pots

STALL NO. 6 - 12 pots

STALL NO. 7 - 10 pots

Stalls should be a minimum of 14’ x 24’. This permits the car to stay tied down without moving it during repositioning of pulls. If stall were smaller, one would have to move the car for side or end pull. Maximum 6’ spacing of perimeter pots keeps power post close to perimeter by not encroaching into center of stall when bridging chains between them (see diagram to right - using a shallow back chain angle will increase chain pressure).

Technical Info Index