Clean air is introduced into the booth through a set of filter doors at the front of the enclosure, and is exhausted through a plenum at the rear of the booth. Air is pulled horizontally fro the front of the booth through the working depth at an average velocity or approximately 75 fpm. The intake and exhaust filter layout is designed for even air velocity throughout the working area of the booth (Consistent air velocity is an important factor in achieving a quality paint job). The filter door is designed with high efficiency intake filters to remove dust anddirt before it enters the paint booth. This will provide a cleaner environment for a quality paint job. The booth is designed with the maximized filter quality to ensure effeicient particulate filtration fron the intake and exhaust filters.
-
(1) 24" Tube Axial In-Line Exhaust Fan (8550 CFM @ 3/8" S.P.) Tube axial fan featurs a continously welded housing for an airtight seal, the propellers are non-sparking cast aluminum for soncistent air velocity at higher static pressures. The universal motor plates will allow adjustable belt tensioning. The bearings are of premium air handling quality, self-aligning, and have a L10 life of 40,000 hours. The belt guard provides protection from the rotating pulley (OSHA Requirement).
-
(1) 3 H.P. Tr-Voltage 208/230/460 Volts, 3 Phase 60 HZ TEFC High Efficiency Motor with Variable Pitch Drive Sheave. Motor features a heavy gauge steel frame, double sealed ball bearings that are mechanically locked on the shaft end, and bolt on motor base for easy removal. The service factors for the motor are 1.15 for 3-phase power and 1.0 on 1-phase power. UL recognized and CSA certified.
-
(8) Deluxe Flourescent Light Fixtures, Inside Access 48" 4-Tube, 265 MA, 32 Watt T8 Ballast, Dual Voltage 120/277 with 85% Color Corrected Tubes Included. Lights are Class I, Division 2 rated. Lights are ETL & ETL-C listed and are also listed for locations having deposits of ready combustible paint residue. Instant start (starting temperature at 0 degrees F.) T-8 electronic ballast provides greater energy savings. The lamp holders are twist in style. The light featuers front/inside access for easy lamp replacement and are equipped with an interlock switch to disable painting operations when light access door is opened.
-
(1) Set Filtered Door Entry Doors (10' Wide and 8'9" High). Doors and 2" tube framed and single skinned with 18 ga. sheet steel for sturdiness and durability. Door hinges are heavy duty for long lasting performance. An airtight seal is created with the durable P-Seal rubber gasket.
-
(1) Industrial Style Exhaust Filter Chamber
-
(1) Personnel Access Door with Panic Latch
-
(1) Dwyer Mark II Manometer (Required per NFPA-33 Fire Code to monitor paint over spray build up on exhaust filters)
-
(1) Set 20" x 20" Intake Filters
-
(1) 20" x 20" x 1" Exhaust Filters and (1) Set of Grids
-
(1) Lot of necessary assembly hardware (Note: Anchor bolts by others unless specified) and exploded view installation drawings for easy assembly.
-
Booth Working Dimsension: 14'0" Wide x 8'9" High x 25'0" Working Depth
-
Approx. Booth Overall Dimensions: 14'4" Wide x 8'11.5" High x 28'5" Overall Depth
-
Made in USA
-
Construction: 18 gauge galvanized steel sheets. Panels are pre-punched and companion flanged for easy assembly. Booth is reigidly reinforced with structural steel construction.
Watch our Paint Booth Video Online