Lisle Pneumatic U-Joint Driver - 18980
Ever wondered why the chassis of your car vibrates at the shift lever? The problem may be due to a bad rear U-joint, and it may be time for some maintenance. It is important that you detect the worn out U-joint and use the Lisle Pneumatic U-Joint Driver to easily and quickly remove the U-joint cap from the driver shaft. It works on most rear wheel drive vehicles.
This tool can be used with an air hammer in place of a chisel bit to take out the U-joint. The U-joint driver brings the yoke down to remove the cap with an air hammer. This tool eliminates the chances of damaging the yoke ends when you are in the process of replacing the joint.
Key Features of the Lisle Pneumatic U-Joint Driver:
- You can use the driver along with an air hammer to remove U-joint caps up to 1-5/16" diameter
- The joint driver prevents damage to the driveshaft and axle shaft ears instead of presses or chisels
- U-joints on certain vehicles come with plastic from the factory, and these must be removed before driving the u-joint caps out
There are no comments for this product.