Equalizer® Set of 9 Radius Patterns, 1"-3" in 1/4" Increments - LY1275
Radius patterns have 9 circles starting at 1" and
increasing in 1/4" increments up to 3".
- Hold the radius patterns against the corner until you
find the correct size.
- Check all four corners to be sure the radius is the
- A quick measurement of the openings and you can make a
Example: With the rubber gasket removed the opening is
20" by 20" and has a 3" radius. Most rubber gaskets have a
5/16" inset from the pinchweld so you should cut the glass 5/16"
smaller all the way around with a 3" radius on the corners. When the glass
is cut it measures 19-3/8" by 19-3/8" and has a 3" radius. If
the gasket is in place, measure to the bottom of the rubber channel and cut the
glass to that size.
There are no comments for this product.